How to repire a HP laptop adapter(2)

Next there's a metal sheet guardian, remove them. On the bottom part it’s soldered to an IC. So heat it using a soldering iron potential earnings you have that extended IC just like you will Hp Pavilion Zv6000 adapter them back later. At this point the strain elimination is kinda disorganized, I had in order to cut it with a cutter to amenable it up next cut the cable. Next I unsoldered the portions from the wire connected around the board. Total there was three wires. First is a outer wire, white wire as well as the blue wire inside. So cut the actual wire and cut it the cables. Solder it on the same location because you did when you removed the good old one. Tape the remaining expose wires and then put back that strain relief. Placed back the metal sheet casing, iron the IC to the bottom part for instance earlier. Close the field and zip. it with a couple of cable ties to keep in place.


And there you've it, I managed to salvage the energy hp dv5000 adapter of my wife’s HP laptop.

PS. Pics are kinda blurry while I only procured them with our phone’s cam. HTC Persona phone camera sucks at natural and lower light!

This gain access to was posted about Saturday, November 6, 2010 at 8: 32 am and is particularly filed under Hardware. You can observe any responses to the entry through that RSS 2. 0 feed. You can leave a reply, or trackback from the own site.
ONLY TWO Responses to “DIY: HP Laptop Power.

How to repire a HP laptop adapter

Got my wife one particular netbooks hp dv6000 adapter last year, the last couple of months it suddenly won’t turn on. The warranty had been out and considered the worst for instance motherboard failure and so forth. Luckily it similar the battery was drained and the power adapter wasn't working to ask for it. After some googling it similar this is frequent on HP laptop power adapters, there's a break going either around the pin side plug or the stress relief. So We were able to pinpoint the problem and just wiggled the particular strain relief and then taped it to position so that it wont move very much. The strain relief is a rubber on that cable wire following main power adapter package. Tape fix hasn't been elegant to look at but it worked.

Several days past the HP Pavilion DV9000 Adapter went dead once more, power supply tape fix seriously isn't working anymore, exhausted seeking to wiggle the tension relief and cable connection wire. Using a different similar power adapter in addition to netbook charged. So back for the power adapter problem I’m sure you can receive a replacement because of this online from $10-$25. But throughout the Philippines perhaps HP service facility or distributor it’s just about around $20-30. If you are DIY like me, It was period to open the idea up look within the insides and do the repair.
What I had to do is minimize th
e wires within the strain relief, take away the soldered cable connections, strip out portions from the longer wire to solder them to board.
The resources I used were being:
1. Hammer
ONLY TWO. Long flat dagger
3. Cutter
SEVERAL. Soldering Iron
A FEW. Cable ties.

So first place the knife flat on the opening of side of the power adapter plus slightly tap them going from starting to up. This can open up true instead of neighbor's it open which has a screwdriver. Do that upon all sides then it might come off.