How to repire a HP laptop adapter(2)

Next there's a metal sheet guardian, remove them. On the bottom part it’s soldered to an IC. So heat it using a soldering iron potential earnings you have that extended IC just like you will Hp Pavilion Zv6000 adapter them back later. At this point the strain elimination is kinda disorganized, I had in order to cut it with a cutter to amenable it up next cut the cable. Next I unsoldered the portions from the wire connected around the board. Total there was three wires. First is a outer wire, white wire as well as the blue wire inside. So cut the actual wire and cut it the cables. Solder it on the same location because you did when you removed the good old one. Tape the remaining expose wires and then put back that strain relief. Placed back the metal sheet casing, iron the IC to the bottom part for instance earlier. Close the field and zip. it with a couple of cable ties to keep in place.


And there you've it, I managed to salvage the energy hp dv5000 adapter of my wife’s HP laptop.

PS. Pics are kinda blurry while I only procured them with our phone’s cam. HTC Persona phone camera sucks at natural and lower light!

This gain access to was posted about Saturday, November 6, 2010 at 8: 32 am and is particularly filed under Hardware. You can observe any responses to the entry through that RSS 2. 0 feed. You can leave a reply, or trackback from the own site.
ONLY TWO Responses to “DIY: HP Laptop Power.